Throttle Sleeve Grips The throttle sleeve is meant for single cable operation. It is not meant to run the push cable. You do not need the push cable, remove it and enjoy your new found throttle performance. Malleus Machined Motorcycle Grips GRIPS DESIGN These grips are design for Honda Shadow and are perfect choice for your bobber or chopper build. The throttle sleeve tube fits most throttle cables but stock Honda Shadow switch housings and the clutch side grip. PROVIDE SOLID GRIP There is no need of external grips for handlebar that will wear out or need replacing. These throttle sleeve and clutch grips are machined from 6061 aluminum. The throttle sleeve anodized with beautiful knurling not too extreme just enough to provide a solid grip to your hand on the handle. FITMENT Honda Shadow VLX600 / VT600 Honda Sabre & Honda Magna Honda Shadow VT1100 Honda Shadow VT750, ACE, Aero, Spirit, Phantom, RS May fit other metric bikes. OTHER PRODUCTS 3L Lockable Jerry Can This 3L lockable jerry can system with a sissy bar mount will remove all of your tiny tank insecurities! Easily remove it with the turn of a key for short trips and lock it up knowing it's not going anywhere when you walk away. 50% Weld-On Hardtail Kit These pieces sleeve inside the VT600 VLX600 frame, no slugs are used, as the hard tail pieces act as the slugs. Make sure to rosette or plug weld all junctions. AIS Block-Off Plates The AIS Block Off Plates is necessary to remove the AIS (Air Injection System) from your Shadow VT600.